|
|
|
|
 |
Drilling rigs
Compressors
Our new Ingersoll compressors Ancillary equipment
Support vehicles
Mobile Mud Cleaning Machine [NEW 2006]
Available to hire
Full workshop facilities for servicing and repair, including large diameter test well.
The rig is equipped with a 10m mast and has both a service winch and heavy-duty winch of 6.6 tonnes capacity. The rig has 508mm clamping and breaking tables to facilitate ease of use during rod change and handling of casings from 150mm diameter to 500mm, thus considerably minimising manual handling. This machine has a depth range of 300m+ and is especially suited to difficult drilling conditions due to its high torque, variable speed, hydraulic top drive head.The machine is fitted with 3” hoses to facilitate either air flush or fluid drilling and perfectly partners the MC80 Mud Cleaning system.We believe this will be the most advanced water-well drilling package currently available in the UK and is ideally mated to our environmental objectives and code of safe working practice.
Beretta T151 drill rig, built in Milan by Beretta Alfredo srl, this compact tracked rig powered by a 98kW Deutz engine, it has a small footprint, and can even be operated by remote radio control if needs be. Drilling to a diameter of 324mm its dual head system contra-rotates the outer casing, so achieving terminal depth is faster, particularly in unstable overburdens. There is a triple clamping system for surface casings and drill rods, and the centre clamp has a 30 tonne jack-up system - exceptionally powerful for this size of machine - essential to retrieve stuck surface casings. It is ideally suited to drilling geothermal boreholes where space is at a premium. Environmental issues are fully addressed, as a fitted preventer system discharges arisings horizontally through a pipe into a skip, helping keep the site clean. This equipment was added to our assets in 2007.
MC80 mobile high performance mud cleaner. Mounted on a 14m trailer, the unit includes a double deck VSM 300, fifth generation, shaker mounted on a hollow section steel frame with underflow tank, mud feed chute, clean mud compartment, Svedala 100 x 75 centrifugal hydrocyclone feed pump with 22 kw motor, 4 No. 5” hydrocyclones, interconnecting pipework, fold-up front access platform, 3 phase compressor, electrical controls and 15m of armoured power cable. The shaker used on the MC80 is a Rigtech VSM 300, high performance, linear motion, double motor shaker with inverter speed control. It has a top deck that uses pre-tensioned panels held in place by pneumatic bladders. The top deck is normally fitted with 10 to 30 mesh screens for the removal of clay balls, lumps of soil, grass, roots, timber, gravels, course sands and other large particles. The lower deck uses 4 No. pre-tensioned stainless steel, fine mesh screen panels with pneumatic screen clamping. Lower deck screens of 84, 105, 140, 165, 200 or 250 mesh. |
|
Klemm 709W top head drive rotary drill rig mounted on new 8 x 4 Mercedes Actros 32/35 truck.This rig has automatic rod handling and carries 160m x 140mm diameter heavy-duty drill rods in its magazine. The machine is fitted with safety trip wires and interlocked guards to meet the latest H & S requirements. The hydraulic system has been designed for use with biodegradable oils and its Caterpillar 3056 DI-T power pack meets all current European emissions and is EPA certified. The Mercedes 32/35 also meets all current emissions legislation and is fitted with disc brakes and ABS as added safety features.
| ||||
